MS3 Gold Box (87-93 Mustang) - IAC Valve Mode Question

So I have the car idling well with no idle valve selected, 750 rpm, timing fixed at 16 degrees. No matter what setting I select when I go to open loop for valve mode, the PW% functions the same. Am I missing something here? I thought when I switched it over to inverted, I could start lower. I am not getting an inversion. I've had a couple of tunes early on that threw "battery volts too low" message for which the only fix I found was to reload the base tune. I'm scratching my head on this one. Any help would be appreciated.

-Tim

Will give that a try. Also, does the test mode recognize the change from normal to inverted? I have been using test mode for the IAC which doesn’t seem to change when I switch. Maybe I should try to control the IAC through the IAC warm up table?

I don’t think I cycled power on that as TS didn’t prompt for it. I will see if that helps with the frequency change later today. Thanks for the tip.