i just recently got this car, first mustang. this is a list of codes that i pulled. codes 15, 22, 35, 51, 53, 54, 67, and 85. when i removed computer to check for constant power to pin 1 for code 15 it had a hypertech chip sticker saying code 15 may be present i did have constant power. on start up it will idle up to 2500 then down to 1500 and after a minute of idling at that it will start stepping down to 900 after car warms up you can turn it off and it will not crank for another 15 min. i did replace tps with a motorcraft and still not getting proper voltage there, any help on where to go/start would be appreciated! just unplugged hypertech chip cleared codes and started car engine light immediatley pulled codes and still have same ones except for 15 is gone with chip out.-when doing the idle checklist trying to set base idle you unplug the iac connector and pull the spout off to control spark advance, by spout are they meaning the chip by the distributer that you pull out to set timing? if so my car shuts down as soon as i pull the chip.