• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

My car CAN'T be burning THAT much oil... CAN IT?!

  • Thread starter Thread starter cjman15
  • Start date Start date Jun 2, 2005
  • 1
  • 2
Next
1 of 2 Next Last

cjman15

Banned
Apr 15, 2004
1,009
0
0
Fairfield, PA
Jun 2, 2005
#1
  • Jun 2, 2005
  • #1
OK, so my Check Oil Light came on about three days ago. I check tha oil, seems to read about normal... maybe even a little bit over. So today I head to work (around 8 mile drive) and it comes on in tha morning. I figure I will check it on my way home if it still comes on when I got off. Sure enough, it came on right away when I started it up, then I headed for home. I get home, pop tha hood, pull tha dipstick... and it's barely reading ANY oil at all! Like just the tip was showing anything... WTF?! It goes from full to down that much in like two days? I know my car is burning oil, but not that much! It leaks a couple drops on tha floor as it sits over night... where's it all going? You think it leaks out while I'm driving or something? Seems like a dumb question, but I'm just frustrated with this oil thing.

Oh yeah, and the whole time over tha past few days... my oil pressure has stayed consistant... if that means anything.

Thanks guy,
-- CJ
 

cjman15

Banned
Apr 15, 2004
1,009
0
0
Fairfield, PA
Jun 2, 2005
#2
  • Jun 2, 2005
  • #2
I drove down to a gas station and I could notice my car starting to tick enough to hear it sitting at idle at tha station. So I put in two quarts of 10w30 and now it's ready way way over tha full line... Now I'm guessing I have to drain out a good bit... what damage could it cause having it over tha full line... I'm guessin' it will burn off quick enough anyhow, ha
 
P

PonyBoy90

Founding Member
Aug 30, 2002
555
0
0
Toronto
Jun 2, 2005
#3
  • Jun 2, 2005
  • #3
I know that having to much oil will lower your hp as more of the crank goes through the oil and this slows things down. I think you may get oil in the crank case which is shouldn't.
 

88 Fox GT

Active Member
Nov 18, 2002
1,674
0
36
Iowa
Jun 2, 2005
#4
  • Jun 2, 2005
  • #4
I am having the same problem. I KNOW my engine burns a little oil. But, it never smokes unless you floor it at like 4000 RPMS and up. Then I get a little blue smoke. But, I have put 9 quarts of oil in it in 2500 miles. I put 5 in for the oil change. Few days later, my oil light comes on and I put another quart in. This puts me at just a litte over full. Few days later, oil light again. Dipstick reads barely anything but oil pressure is always normal. The check oil light comes on like every 4 days. It's terrible.
 

cjman15

Banned
Apr 15, 2004
1,009
0
0
Fairfield, PA
Jun 2, 2005
#5
  • Jun 2, 2005
  • #5
Yeah, my pressure is always constant... pulses with the engine rev and everything. I get some heavy smoke sometimes when I'm going down a hill and decelerating in third tachin' around 2k-2.5k or under WOT sometimes, but not that much. I guess it's just something I gotta deal with til I get it rebuilt or buy a new crate motor... 170k miles are soon to turn over......
 

Michael Yount

Mustang Master
Apr 10, 2002
9,039
6
79
Charlotte, NC
Jun 2, 2005
#6
  • Jun 2, 2005
  • #6
"But, I have put 9 quarts of oil in it in 2500 miles."


DING, DING, DING, DING!!!! Ladies and gentlemen - we have a winner!!!

Well - it ain't rocket science. It's either leaking it or burning it. If it's leaking, no way to tell how much it's burning. To nail that down you'll need to be sure it's not leaking any. If it's not leaking, and you're using that much you've got major engine issues that will likely require an overhaul to solve.

cjman - sounds like you might have some sort of malfunction with your oil level sensor.
 
8

89rdgt

New Member
Apr 24, 2004
103
0
0
Washington
Jun 2, 2005
#7
  • Jun 2, 2005
  • #7
damn i thought mine was bad 1qt ever 1k. But i bet you dont have a cool little knocking noise to go along with that do you....
So does that make me the winner?
 

SAYNOTORICE

New Member
Aug 21, 2003
152
0
0
Massachusetts
Jun 2, 2005
#8
  • Jun 2, 2005
  • #8
i was having same problem...but luckily i knew where the leak was coming from...i would check over the engine thoroughly but two places to inspect closely are...1)rear main seal 2.) intake seal...the intake seal is tricky cause it may not be too obvious it is leaking, check for small pools of oil around distrbutor, also if its the rear part of the intake it may seem like main seal...just double check...you probably have a case of both burning oil and a leak
 

88stangmangt

Active Member
Nov 25, 2003
2,332
1
48
Stafford,VA
Jun 2, 2005
#9
  • Jun 2, 2005
  • #9
5.0's only run good when there burning oil.....and the rear main seal are the #1 loser for oil leaks...chances are both of you arnt burning it if you dont see a trail of blue smoke following you..climb under the car and see where it is all going....also make sure you are on level ground when checking the oil.
 

Michael Yount

Mustang Master
Apr 10, 2002
9,039
6
79
Charlotte, NC
Jun 2, 2005
#10
  • Jun 2, 2005
  • #10
Back of the valve covers is VERY common as well - and people often mistake it for rear main because it drips off the bottom of the bell housing (along with other places). Many rear mains are replaced only to leak just as badly afterwards because the real culprit was a clogged pcv screen/valve which was increasing crankcase pressure FORCING oil out where ever it could get out - often the front and rear seals.

No - you don't win a prize for the knocking sound and oil consumption. But blow it up big time when the knock lets go - and post a picture of the broken pieces - now that'll make you a winner.
 

Michael Yount

Mustang Master
Apr 10, 2002
9,039
6
79
Charlotte, NC
Jun 2, 2005
#11
  • Jun 2, 2005
  • #11
And for what it's worth - with about 72K on the motor in mine - it's bone dry on the outside, and doesn't use a drop between changes. They're not required to leak or burn oil.
 

cjman15

Banned
Apr 15, 2004
1,009
0
0
Fairfield, PA
Jun 2, 2005
#12
  • Jun 2, 2005
  • #12
Would 20w50 help to not burn so much if it is burning it?
 

88stangmangt

Active Member
Nov 25, 2003
2,332
1
48
Stafford,VA
Jun 2, 2005
#13
  • Jun 2, 2005
  • #13
good god might as well use pancake syrup..... i wouldnt go any higher than 15-40 and that is even a diesel oil. All my fords ran great even if they smoked.....and micheal yount is dead on about the pcv system. is all goes back to good up-keep......
 

Michael Yount

Mustang Master
Apr 10, 2002
9,039
6
79
Charlotte, NC
Jun 2, 2005
#14
  • Jun 2, 2005
  • #14
20w50 might help - ok to try it in the summer; but it's too heavy for cold winter starts.
 
8

8950HO

New Member
Mar 31, 2005
658
2
0
Jun 2, 2005
#15
  • Jun 2, 2005
  • #15
Michael Yount said:
Many rear mains are replaced only to leak just as badly afterwards because the real culprit was a clogged pcv screen/valve which was increasing crankcase pressure FORCING oil out where ever it could get out - often the front and rear seals.

Excellent point,everybody should read this.
Click to expand...
 

Michael Yount

Mustang Master
Apr 10, 2002
9,039
6
79
Charlotte, NC
Jun 2, 2005
#16
  • Jun 2, 2005
  • #16
Anyone who's ever owned a Volvo with an OHC engine knows all about clogged pcv/flame-traps and resulting oil leaks.
 

HISSIN50

"How long does it take to get help in here?
15 Year Member
Nov 29, 1999
31,179
34
129
Jun 2, 2005
#17
  • Jun 2, 2005
  • #17
Where is the unofficial supporter of 20W-50 (Crazy Pete)?

Michael is right - in the old days guys would run SAE 30 weight in motors that burned some oil. These days 20W-50 works pretty well. I have done it in the summer, not for consumption reasons, but for pressure and temp issues (10W-30 is like vegetable oil here when it is 110*F outside and the motor is over 200*).

Good luck with it.
 

Michael Yount

Mustang Master
Apr 10, 2002
9,039
6
79
Charlotte, NC
Jun 2, 2005
#18
  • Jun 2, 2005
  • #18
It's really enlightening to have an oil temp gauge - as the oil temps climb with ambient, in mine you can see the pressure drop. I generally match viscosity to ambient temps running 5w-30 in the winter time; and 10w40 in the summer. I'm about to switch the Volvo to the same oil I run in my wife's Bimmer - synthetic Shell Rotella T (diesel spec) in the 5w-40 weight. That way I can run the same oil year round, and in both cars.
 
8

89white50

Member
Nov 16, 2004
440
1
18
central MA
Jun 2, 2005
#19
  • Jun 2, 2005
  • #19
because the real culprit was a clogged pcv screen/valve which was increasing crankcase pressure FORCING oil out where ever it could get out - often the front and rear seals.
Click to expand...

Last summer, im sure the pcv system started the whole mess, the back intake gasket was leaking. Bro-inlaws a master ford mechanic, so he knew what it was right away. But yes it drips down the bellhousing and tranny, and also it would drip onto my cats and burn oil that way. I changed all the gaskets, main/rod bearings, front rear seals...everything. Now, about 6k later im back to smelling burning. Mostly is the valve seals...hard engine breaking(getting hard on it then let completely off in the same gear), gives me a small amount of smoke. Im sure some is the rings with 120+k on those, but dont think its much. I go through a quart about every 1k. Hence, instead of doing an HCI this summer, im buyijng a sportsman block, and building a 347 stroker with my bro-inlaw. Wont be done till next summer, but much less of a PITA. and more ponies
 

HISSIN50

"How long does it take to get help in here?
15 Year Member
Nov 29, 1999
31,179
34
129
Jun 2, 2005
#20
  • Jun 2, 2005
  • #20
Michael Yount said:
It's really enlightening to have an oil temp gauge - as the oil temps climb with ambient, in mine you can see the pressure drop.
Click to expand...
Very wise and true. (You know, i bugged you about oil coolers over a year ago and I still have not done it. I just keep running M1 15W-50 in the summer). One of these days.
 
  • 1
  • 2
Next
1 of 2 Next Last
You must log in or register to reply here.

Similar threads

T
Oil burning on my recently buil 302
  • The blk67
  • May 15, 2026
  • Fox 5.0 Mustang Tech
Replies
3
Views
160
Fox 5.0 Mustang Tech May 15, 2026
Noobz347
Engine Gas in my oil
  • limp
  • Jun 15, 2025
  • Fox 5.0 Mustang Tech
  • 2
Replies
35
Views
1K
Fox 5.0 Mustang Tech May 16, 2026
Mindseye007
Electrical Issues with my 2006 mustang gt
  • VerneVdV
  • May 22, 2026
  • 2005 - 2009 Specific Tech
Replies
0
Views
94
2005 - 2009 Specific Tech May 22, 2026
VerneVdV
Engine 87 NA - Tune or no Tune needed?
  • R82148V
  • Sep 17, 2025
  • Fox 5.0 Mustang Tech
Replies
8
Views
379
Fox 5.0 Mustang Tech Sep 17, 2025
R82148V
Engine New Oil Leak Help.
  • Slo5Oh89
  • Mar 14, 2025
  • Fox 5.0 Mustang Tech
Replies
8
Views
611
Fox 5.0 Mustang Tech Mar 19, 2025
Slo5Oh89
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?