mystery 5.0

[stangkid95]

i know this has nothing to do with mustangs but the motor in my f150 isnt the stock motor and i have no idea what kind of motor it is.. its a 302w bored .40 over. with for eye brow pistons and roller lifters what kind of motor do i have? is it a mustang motor? any infomation will be helpfull

 

[ID89GT]

Look at the code on the block and look that up, should give you a pretty good idea

 

[Noobz347]

Mystery 5oh 3000!!!

 

[stangkid95]

Do u know exactly were the numbers are on the block? And someone said look on the heads. If so were would they be on the heads cause theirs a couple different sets of numbers

 

[Opposedodie]

Back of the block between the heads on a 302 in some cases I have seen it also by the base of the distributor on the Boss blocks ...

 

[Gearbanger 101]

The mustangs and F150's after '87 both used the same E7TE heads and block. As such, the F150's were machined for a roller cam, but did not use one. The pistons were cast and dished and may, or may not have had the valve reliefs cut into them.

 

[Maryland Stang]

The mustangs and F150's after '87 both used the same E7TE heads and block. As such, the F150's were machined for a roller cam, but did not use one. The pistons were cast and dished and may, or may not have had the valve reliefs cut into them.

'93 and up F150s with automatics had the roller cam. My '95 definately has one.

 

[stangkid95]

thank yall for the advise it was much needed. im just trying to figure out what that guy put in the truck b4 i got it. its a 91 f150 4x4. and its a pain going to get parts and telling them i need plugs for a 91 f150 and they end up being wrong. but thank yall for the advice.