NEED ADVICE ASAP on D&D Performance Tranny Master Build Kit!

FiveOhhStang

New Member

Jan 27, 2003

299

0

0

Sanger, Cali.

Jun 8, 2004

#1

• Jun 8, 2004

• #1

I cant find a link(So I need one if possible.) I found this tranny online SINCE MINE IS BLOWN. My car is just sitting by itself in the garage Does this sound like a good deal on a tranny?

Tranny

I need this, and am ready to get it, just want some feedback. Lemme know, as always THANKS STANGERS!
-Nick

 

drgn5.0

Founding Member

Mar 13, 2001

603

0

0

Jun 8, 2004

#2

• Jun 8, 2004

• #2

sounds like a good deal to me, question is can you really trust people anymore?

 

FiveOhhStang

New Member

Jan 27, 2003

299

0

0

Sanger, Cali.

Jun 8, 2004

#3

• Jun 8, 2004

• #3

That is sooooo True. I am asking him a few questions about it, but yeah...honestly Im basically going to go off his word if my pops gives me the money.
-Nick

 

D

Draginmadd

New Member

May 10, 2004

18

0

0

Ft.Lauderdale

Jun 8, 2004

#4

• Jun 8, 2004

• #4

Have u tryed the junk yards yet????300 bucks seams awfull steep if all u need is a tranny.

 

FiveOhhStang

New Member

Jan 27, 2003

299

0

0

Sanger, Cali.

Jun 8, 2004

#5

• Jun 8, 2004

• #5

Well, the problem is, I dont have many mods yet, but I drive it like I stole it sometimes...so basically I want it to hold up well for years to come.
-Nick

 

8

89stanglx

Founding Member

Jan 27, 2000

162

0

0

West Lafayette, IN

Jun 8, 2004

#6

• Jun 8, 2004

• #6

$300 is not steep for a used t-5. Most junk yards want 350 to 400 for them

 

dvs bullet

New Member

Feb 20, 2004

326

0

0

Ontario, Canada

Jun 8, 2004

#7

• Jun 8, 2004

• #7

what is blown on yours? if it is the sinchros they are not that hard to replace

 

FiveOhhStang

New Member

Jan 27, 2003

299

0

0

Sanger, Cali.

Jun 8, 2004

#8

• Jun 8, 2004

• #8

The Gears themselves are shot, 1-3rd is gone, had to drive about mile starting and driving in 4th

THIS IS WHAT HE E-mailed me, without redoing the Gears themselves, will it survive some punishment?

Hello, The tranny was rebuilt with a D&D 102 piece rebuild kit These are the parts that were replaced
1st and 2nd three piece synchronizer rings
3rd and 4th kevlar synchronizer rings
brass 5th synchronizer ring
front and rear seals
rear tail housing bushing
input roller bearings
all main shaft gear bearings
all main shaft bearings
all countershaft bearings
shift fork pads
front bearing preload shims
synchronizer keys and retaining rings
shifter bushing
snap rings
spacer washers
1st gear bearing sleeve

The only gear replaced was revearse gear. All the other gears were fine. Tranny hasnt even been installed after rebuild, decided not to convert to 5 speed. Left the AOD in the car. I live in washington state

 

dvs bullet

New Member

Feb 20, 2004

326

0

0

Ontario, Canada

Jun 8, 2004

#9

• Jun 8, 2004

• #9

Sounds like it's been built right , if the gears aren't worn then there is no point in replcing them, unless you are going with a hardened gear set.

 

FiveOhhStang

New Member

Jan 27, 2003

299

0

0

Sanger, Cali.

Jun 8, 2004

#10

• Jun 8, 2004

• #10

so is it a good deal?

 

Rick 91GT

Mustang Master

Nov 29, 1999

9,692

95

99

PA

Jun 8, 2004

#11

• Jun 8, 2004

• #11

Well that rebuild kit runs around $170 and is very nice, I have used it in the past, comes with good bearings and upgraded syncros...sounds like the tranny is ready to go.

To do yours it would cost you over $550 in parts (new imput, counter shaft, 2nd/3rd gear cluster, master rebuild kit) plus labor to build it, I charge $250 for that.