Sup guys (and gals). I recently installed a BBK throttle body (65mm) onto my 2003 V6 Coupe. Well, the problem I had was, when I first fired it up, it would idle high. At one point, while I was letting it idle, per BBK's instructions, for a few minutes to let the computer adjust, I noticed that the headers on the left bank were glowing . I don't think that's normal, so I shut it off quickly, waited a few minutes, then fired it back up. It started right away, but the headers weren't glowing. I adjusted the idle as much as I could to try and get it back to the factory idle (it's idling right now at about 900 rpm's and drops to about 700 in drive). I have no idea what made the headers glow or what could be the problem. Have any of you experienced this issue? Please let me know what could have gone wrong. Everything seems fine now, but I'd like to know what could have caused such a problem when I was only adjusting the throttle body and air induction. Also, am I good at those rpm speeds or does more adjusting need to be done? Having the CAI and throttle body spacer already in made the install a pain, which was made even more so by the strut tower brace. But anway, if you have any advice or can help me out, I'd appreciate it. Thanks alot in advance.