Need E-Brake help asap!!

I`m not sure if the SN95 e-brake is like a foxbody,but if it is you have to reset the spring tension on the hand brake assembly.

I did mine recently.I removed the hand brake assembly from the car,put it in a vise with the spring facing up.

Then I used what was left of the broken cable and attatched a pair of vise grips to the cable and pulled until the small hole on the side lines up with the hole on the part with the teeth.

When the holes line up,put a nail through to hold the spring tension in place.
Install the handle assembly and cable in the car and connect the cables to the equalizer under the car.

Twist out the nail with a pair of pliers and bang,it`s all set up.

May have to reposition the handle assembly a bit to line it up with the cable.