Need Help, Lost 1/4" Bit Extension in Dist Hole...

JDS68Stang said:

I would try and locate a long (1"-1 1/2") slim rounded magnet, duct tape it good on the end of a simlilar sized small diameter steel rod, most especially around the magnet sides to cut down on it drawing to the sides as it's lowered. Then give it a shot.

If that didn't work I'd blame the wife and make her miserable,lol, then tell her to go get the part out.

When she comes in 10 minutes later smiling holding the 1/4" bit don't even ask her how she did it, she'll probably say I put my gum on a wood stick and pulled it right up, lol

All kiddin aside, good luck gettin that out, I wouldn't want that floatin around in my pan either.

Click to expand...

66 Tiger said:

I definitely blamed her, but in the end, there is NO WAY that I could possibly make her any more miserable! ( I hope she never stumbles on this. Ha, haa. )

Anyway - in the end, I dropped the pan after not having any success with the magnet technique. I would have liked to leave it in there but with the luck that I have been experiencing this week I just didn't want to chance it.

Thanks everyone.

Click to expand...