Need help with "p" motor swap

elderstang

New Member

Jun 2, 2008

23

0

1

Taylorsville, KY

Jun 2, 2008

#1

• Jun 2, 2008

• #1

I've swapped a 97 explorer motor in my 95 gt. i have put everything new on it and cannot get it to start. Ive put a coil, stator, ign. module, cap, rotor, wires, plugs, even a new timing chain, and it wont start. i know the timing is correct, and it is getting fuel. Im wondering if going from a crank trigger to a distributor is the reason. thanks to any help.

 

desertcox05

New Member

Oct 3, 2007

379

0

0

south atlanta

Jun 3, 2008

#2

• Jun 3, 2008

• #2

that i think would be your prob. you wound need to swap out the OBD II puter and harness from the exploder or convert the newer motor back to the OBD I harness. I don't know for sure maybe someone else has done this before and can chime in

 

BlownFiveLiter

have car, will race....wait, it doesn't run

15 Year Member

Nov 29, 1999

3,133

18

108

Chicagoland

Jun 3, 2008

#3

• Jun 3, 2008

• #3

The DIS to distributor swap has no bearing on it not starting. I'd recommend checking out the Cranks OK, but No Start Checklist for Fuel Injected Mustangs to give you some ideas on what to check.

 

elderstang

New Member

Jun 2, 2008

23

0

1

Taylorsville, KY

Jun 3, 2008

#4

• Jun 3, 2008

• #4

Thanks for the ideas. I got it started 4 about 2 minutes, then it stalled and wouldnt start again. Guess i recheck everything for the 10th time.

 

B

blueblazes

New Member

Jan 11, 2008

76

0

0

Jun 3, 2008

#5

• Jun 3, 2008

• #5

are the explorers ho motors?

 

elderstang

New Member

Jun 2, 2008

23

0

1

Taylorsville, KY

Jun 3, 2008

#6

• Jun 3, 2008

• #6

yes, they are. they have the same firing order as the HO. the only difference, was the harmonic balancer. It had a crank trigger, and i took it off, and replaced it with old balancer.

 

Blackened302

Active Member

Jul 21, 2005

1,439

0

36

South TX

Jun 3, 2008

#7

• Jun 3, 2008

• #7

this may be worthless, but do you have a CEL? maybe pulling the codes will give you a lead?

 

elderstang

New Member

Jun 2, 2008

23

0

1

Taylorsville, KY

Jun 5, 2008

#8

• Jun 5, 2008

• #8

Yes, i pulled them but the only thing i got was an intake air temp. to high. changed the sensor, and that went bye bye. I think my trans harness might be messed up, going to try that next.