need some to check my temp #'s

[cj99]

Fresh rebuilt 1986 (302/307 after bore)
0 miles and about 20 mins runs time on motor
check profile at bottom of post for other info
Temp Test one Mustang 9-1-06
Outside temp : 115/112
Intake temp before run : 110
Intake temp after run : 117
Exhaust temp before run (ds) 108 (ps) 107
Radiator Temp before :109
Radiator after run :159
Run test : 5 min

Exhaust : (ds) 445 (ps) 448
451 390
447 430
454 449

Test taken with hand held Raytek gun 2 inch down exhaust ports on header
timing unknow , have not yet put a timing gun on it, just set were motor sound good
thanks
chad

 

[HISSIN50]

Am I missing something? Unless those temps are Centigrade I don't see an issue.

Good luck.

 

[cj99]

just checking

no there not C there F. just got the motor running and I have a broke wire that I am trying to trace down under the engine...did not know if it was a o2 sensor
and wanted to make sure she was not running lean (hotter than normal).
have not drove care yet just ran it a few time for about 5mins.

 

[HISSIN50]

It sounds fine to me. A fresh mill will probably run a little hot for a bit anyhow. Once you get the timing dialed in and such, it should be easier to gauge what's going on.

Was it just idling? I'd assume there was no load since you dont have timing dialed in yet.

As long as it stays under about 190*F, I'd be happy myself.

Have fun!

 

[cj99]

ya , just idling... have not drove it yet. matter of fact it only has like 20 mins of run time total.