Need To Get My Injectors Serviced

[ace305]

I purchased a set of 36# injectors used. I would like to get them professionally look over. this is for a 2.1 KB build. any suggestions to contact?

thanks

 

[ace305]

will these BOSCH 0280155868 fit my 2001 with Kenne Bell?

 

[wmburns]

I have had good experience using InjectorRX.com. Once cleaned and flow tested they are as good as new.

I almost always have the injectors serviced during a major motor project ESPECIALLY when I use (as I often do) a replacement salvage yard motor. It just seems like cheap insurance to me.

 

[ace305]

awesome thanks

 

[Noobz347]

I purchased a set of 36# injectors used. I would like to get them professionally look over. this is for a 2.1 KB build. any suggestions to contact?

thanks

I don't think those injectors are going to be large enough without an accompanying Fuel Management Unit (FMU).

On a Windsor block, 42# are barely adequate over the top of a healthy build.

How much boost do you plan to run and how is the tuning being accomplished?

 

[ace305]

Noob,

36 is the size KB recommends with the 2V stock set up. I will be running the booster pump from KB

 

[Noobz347]

Noob,

36 is the size KB recommends with the 2V stock set up. I will be running the booster pump from KB

I gotcha. What all came in the 2V kit? The Boost-a-pump, was there anything else? A tune of some sort?

 

[ace305]

KB is sending a computer chip tuned for my setup. They recommend this due to running safe.

 

[Noobz347]

KB is sending a computer chip tuned for my setup. They recommend this due to running safe.

Nice. Do you have a method in mind to monitor AFR? Does their kit include a wide-band sensor?

 

[ace305]

I am going to use a aftermarket AFR gauge. The kit I have did not come with a sensor. it may be available through them.

 

[Noobz347]

That thing should be a ton of fun on the street man. It'll be like completely different car.