So I got the 66 into the barn. It was a long haul from CA to UT but we made it with no problems. However, the little pony is not very well. She turns over fine but does not want to fire up completely. It seems like it wants to start with some cylinders firing but doesn't fire up all the way. I believe it is a timing issue. The PO had a a new carb, alt, and distributor installed recently. The PO said it was running up until about a week ago. When I went to check the dist it was not tightened down and would turn quite easily. I tried moving it to different positions with no luck. Its getting gas and spark. I went to make sure the dist rotor is in the correct position but I can't find the timing marks on the HB. Also the pointer on the front cover is not there. I do see what seems to be a broken-off stud/bolt where I believe the pointer should be. I'm gonna take a wire brush to the HB to see if I can locate the timing marks. If I can't find them what would ya'll suggest be my next step? Also, I want to hook up a remote starter button. I know one of the button wires goes to the positive terminal of the battery but which post on the starter relay does the other wire go to...the small ignition switch terminal or a different one?