I just installed a set of new cross drilled and slotted rotors with ceramic powerstop pads. I also replaced my caliper. Problem is, when I go to stop it makes a bang sound and squeels.
Here's a few things I was wondering. Could it be the caliper bolts? I tightened them up but they never got too tight. They basically spun on the dowels. It only seems to happen when I'm going very slow and then hit the brakes.
Also, I noticed that the rotors were a little difficult to turn by hand after I installed the new stuff. Is this normal? How much resistance should it have?
Here's a few things I was wondering. Could it be the caliper bolts? I tightened them up but they never got too tight. They basically spun on the dowels. It only seems to happen when I'm going very slow and then hit the brakes.
Also, I noticed that the rotors were a little difficult to turn by hand after I installed the new stuff. Is this normal? How much resistance should it have?