Noisy T5...Going Bad?

onefstsnake

New Member
Nov 25, 2005
792
1
0
Northern VA
Well I broke an axle a week ago and just got the car back.

I replaced both axles and the differential.
31 Spline Moser Axles and an Auburn Pro Locker w/ 3.73's

Well Maybe its just bacause I havent driven the car in a week, but the tranny seems alot noisier...
When I get off the gas and leave it in gear it sounds like rocks tumbling around...

Seems a little notchier too when I shift. Im wondering if I hurt the tranny when the axle broke...

Also, do T5's break often when launching hard? Or do they normally break from shifting hard?

This car is my DD so I dont wanna break much...

Thanks.
Ken
 
I have broken mine both ways. I have sheared the teeth clean off 3rd and 1st. So yes on launch and yes on a 2 to 3 power shift. Of course I have a lot of power. But I have rebuilt many a T5 and they are known to break with abuse. Unless they fooked up when they did the rear end. Can you tell for sure that the noise is coming from the trans?
 
yeah I can feel it in the shifter.

I can usually feel a little vibration in the shifter, but it seems to be more than normal now. Unless Ive just forgotten how it feels...

But I know its noisier.

Also, If Im in the higher RPM range of 1st or 2nd gear and then put the clutch in I get alot of noise untill I put it in neutral and release the clutch. Not sure if this is normal or not...

BTW Im putting down 220rwhp and 285rwtq and running MT DR's
 
I had a similar sound out of my freshly rebuilt transmission. Turns out that the roller bears that goes inbetween the input and output shaft were extremely soft and flat spotted. It ate up both of my shafts. Try the fluid first but it could be a bad bearing. The kit I used was from Hanlon. Hopefully it was just me that got a bad set of bearings(the caged bearing on the input was a bit soft too).
Kevin
 
Kinda an old post but none the less:

I just developed this same sound (I described as "rocks tumbling around") in my drivetrain (T5 with about 25k, 7 year old king cobra clutch - still grabs great, adjusted properly). It's been getting worse.

Also, when I roll up to a stop sign, if I put the clutch in, it sounds like the clutch disc is spinning for a few seconds, slowly spinning down and then stops - with the car still moving. I had 2 helpers for just a couple hours and we managed to get a new throw out bearing in but that was all we had time before we had to get the car back together... So it's not that. But it's definitely something around the clutch. Seems to be related to engine speed, not car speed. And it seems to intensify if I get on the brakes without putting the clutch in...

Did you resolve your problem, onefstsnake? What was it?
 
Fluid was changed and refilled. No difference in noise.

Ill pick up the Astro gear and shaft set and a new clutch, TOB, pilot bushing and rear main seal.

Should be a weekends worth of work...

The car isnt going anywhere soon so Ill probably just drop the trans tomorrow and start taking it apart.