Not 5.0 question, but tech.

dstanggt50

Founding Member
Sep 13, 2000
1,316
0
0
Woodinville, WA
I'm doing an alternator for a 96 honda passport, 3.2 v-6, I thought this was going to be simple, only one plug and one power wire, so I replaced and have to jump the car because of the drained battery and my jumper cables started to smoke, like catching on fire or something. I don't have the cables crossed, new battery and terminals are clean. Could the actual alternator be causing this problem:shrug: I dont' have anything crossed, just one power wire and one plug.
 
So if the alternator isn't charging, it will cause the cables to jumper cables to burn??:shrug: , I thought maybe something to do w/the regulator or something overcharging??. It didn't do this before I replaced the alternator, and I double chk my install, looks good, like I said, only a couple of wires, it would be pretty hard to mess this up.
 
I don't see how the alternator would cause the cables to smoke. Make sure you have them connected correctly; hook up on the jumper (good battery) car normally and attach the red to the positive battery terminal on the honda - the black should go to a good ground - not the negative battery terminal (it could, but this is just in case your battery ground is bad).
 
If not mentioned, double check that all cables are tight. Heat and smoke can come from loose connections (resistance).

Good luck.