Not a Good Project Day.

Orderd 2 water necks since chrome was leaking..from Summit. The billet and alum. ones. Took chrome junker off..it was the bypass hose cracked. Ended up using the aluminum one...it's a nice piece for under $20.

Got my Vortech pulley in finally...SAME size as what I already have. Have to return IT now and wait.

Went to put on BIllet pedals. All hacked up and cant get them to fit. ANY HELP ON THIS IS APPRECIATED!

Only thing that went well was I relocated the ACT sensore to a hole in the number 5 runner of the lower Holley. Will give Wes a more accurate reading for helping with the tuning since it is post blower

YEAHLOH95 said:

i know what you mean about the neck i had trouble with mine too, can't you put the act in the discharge pipe ?

Click to expand...

That part of the install was no problem. The port where I located it to is the perfect size and it's just past the #5 injector, so it's barely visible. Didnt want to tap.

ProKiller said:

what pulley did you decide to go with RC?

Click to expand...

I wanted to go just one down, so I went with the 3.12, only to find out that the 3.12 was already on, so I just ordered the 2.95. That should be a good balance of performance and safety on the equipment.
RC