to anyone that has done an aod to tremec 3550 swap, i have my flywheel, and clutch installed. I was ready to bolt my bellhousing and tailshaft onto the tranny, but the aod tailshaft does not go onto the tremec 3550
so i am going to get a new tailshaft, but was wondering if i need anything else, such as a crossmember ( i have the aod double hump corssmember and was told that was what i needed ), also the yoke and the driveshaft ( i was also told that i don't need different ones, but now i'm not so sure, do i need a different length driveshaft or dofferent size yoke?), any and all help will be greatly appreciated.
so i am going to get a new tailshaft, but was wondering if i need anything else, such as a crossmember ( i have the aod double hump corssmember and was told that was what i needed ), also the yoke and the driveshaft ( i was also told that i don't need different ones, but now i'm not so sure, do i need a different length driveshaft or dofferent size yoke?), any and all help will be greatly appreciated.