Not sure what this is called?

savegoodautonfg

New Member
May 11, 2005
1,085
0
0
If you look under your car and you see the oil pan right after that is like what i think it where the transmission start but you can see like a little lip that comes down in front of the transmission i believe. i hope someone will understand me. the reason why im asking is beacuse my tranny is leaking off of there and one other place.
 
engine rear plate is what it is called i call it a dust shield.if you have a leak dripping from the shield its may either be your rear main seal or the front tranny seal leaking or even both..it also could be leaking from the valve covers and running down the back of the motor..
 
What is involved in changing these seals?

And where is the front tranny seal located along with the rear main seals. im not familar with either.

is there another name for the front tranny seal?

Bill do you have aol isntant messagner?
 
Removal of the tranny is nec. to replace the input shaft seal. You have to unbolt the retainer and then the seal comes right out of the retainer.

Rear main is the same, except you have to take off the bellhousing, clutch, flywheel.. then you get to the rear main. Cheap part, but hours to replace.
 
PoopDawg said:
Removal of the tranny is nec. to replace the input shaft seal. You have to unbolt the retainer and then the seal comes right out of the retainer.

Rear main is the same, except you have to take off the bellhousing, clutch, flywheel.. then you get to the rear main. Cheap part, but hours to replace.

How are you suppose to know if either of them need to be replaced?
 
i have aim instant messeger click on the yellow man next to my signature if you have aim instant messenger to instang message me i'll turn mine on...and to know if either need replacing the best thing is to determine the leak is coming from either of the two locations and as PoopDawg stated above you need to acess the seals and since there in the same general location i would replace both...
 
If it's engine oil, it can also be a valve cover leak.

If you remember, in one of those PM's I mentioned making sure your PCV was up to par - it was to make sure a leaky RMS wasnt actually just a side-effect of clogged crankcase ventillation (and not actually an issue with the RMS).


Good luck.
 
HISSIN50 said:
If it's engine oil, it can also be a valve cover leak.

If you remember, in one of those PM's I mentioned making sure your PCV was up to par - it was to make sure a leaky RMS wasnt actually just a side-effect of clogged crankcase ventillation (and not actually an issue with the RMS).


Good luck.

The PCV has been replaced when my engine was put in which was in May 06'
 
bill302 said:
i have aim instant messeger click on the yellow man next to my signature if you have aim instant messenger to instang message me i'll turn mine on...and to know if either need replacing the best thing is to determine the leak is coming from either of the two locations and as PoopDawg stated above you need to acess the seals and since there in the same general location i would replace both...

ARe you saying that you need to access the seals to see if they are leaking or im kinda confused. also where exactly are both so i can see where it's leaking.. the only place i see is on that engine shield at the bottom lip. its leaking on this other piece a little further to the back of the car.
 
Whoa, I dont know what others think, but if your engine was replaced a couple months ago, NO engine seals should be leaking.
 
Roland69 said:
what kind of fluid is it

Definetly looks like tranny fluid. like my hwole transmission has fluid on it. bc of the blowby you know. but like when i get out of my car and look under it after a drive. u can see it coming off the engine shield and somewhere else.

it could be oil off the engine shield tho.

the other place i believe the tranny fluid is coming from i dont know what it is called.
 
HISSIN50 said:
Whoa, I dont know what others think, but if your engine was replaced a couple months ago, NO engine seals should be leaking.

Yea i know i already got the rear output shaft and the crank seal leaks fixed.

If it is'nt my engine leaking what else could it be?
 
HISSIN50 said:
Whoa, I dont know what others think, but if your engine was replaced a couple months ago, NO engine seals should be leaking.
+1 i'm with you JT it should not be any of the motor seals if the install or rebuild was done properly but if you use a white cloth and place it on the ground where its leaking you should be able to determine that way if its tranny fluid it will be red...what was the condition of the motor when you put it in...rebuilt or used pulled from another car and/or what seals were replaced before install?
 
bill302 said:
+1 i'm with you JT it should not be any of the motor seals if the install or rebuild was done properly but if you use a white cloth and place it on the ground where its leaking you should be able to determine that way if its tranny fluid it will be red...what was the condition of the motor when you put it in...rebuilt or used pulled from another car and/or what seals were replaced before install?

THe install was definetly done properly, my mechanic is very very good. I'm going to try that white cloth thing. Where is the rear main seal located and if its the rear main seal should it be oil or tranny fluid. I went through Promar Engines in NJ and i got a rebuilt long block. Everything was replaced seal wise.
 
It is leaking from the engine shield and the part that is directly under where the shifter goes. its a black part.

it looks yellowish the fluid but its coming off the tranmission for sure.

I think the crank seal is btwn the oil pan and the engine shield and if it is it's not leaking.