Oil Dipstick question

kpack5982

Yeah, it was pretty stiff, but eventually a buddy
Jul 13, 2005
325
1
19
Granger, IA
I just got done putting headers on my car and instead of taking off the oil dipstick like I should have I just bent it out of the way, like a moron. So I pulled the dipstick out to check the oil after I was done and low and behold it wouldn't go all the way back in. So now the tube the dipstick goes in is bent to hell by the oil pan. How do I remove the tube? Does it unscrew or what, the chilton doesn't say. Also, would I have to drain the oil to replace the dipstick tube? AHHH, this thing is frustrating!!!:bang:
 
yes, just as Blk91stang stated it should just pull out with enough force. dont worry about spilling oil it does not reach this level...if you have trouble pulling tube out you can use a flat screw driver at the base of the block where tube enters and pry under the bevel in the tube between bevel and block this will loosen the tube. as Blk91stang
stated coat the new oil tube under the bevel with rtv and insert into hole after it inserted into the hole i also used an adjustable wrench and adjusted it to the size of the tube above the bevel, and tapped the adj. wrench driving tube into the tube hole to get a good seat ensuring tube wont blow out.....
 
I'm just gonna plug the hole, well at least for now, I plan on a bigger oil pan here soon anyways. Is the part number for the hole Clevite 219-2185? Anybody have experience pluggin the hole with this plug from napa?
 
Yeah, I just saw that somewhere and was curious if you had to thread the hole first or what? I wondered what it looked like, i read that it was an "expansion plug"
 
actually that is what I did do. I used the expansion plug thing and it worked great for a while, but I needed to check my oil and got one of the nice adjusting or whatever they are called. Can't remember the brand name but starts with an L and is a hellalot nicer than the stock one.:D