ordered the front and rear Bullit brake kit.

[FordStang]

just ordered the kit yesterday should have it by wensday. ordered it from MustangParts.com 13in rotors for the front and 12 for the rear. Also comes with calipers (red with the pony) and pads and hoses. just wondering if all this is direct bolt on? I asked the guy and he said yea if not what do i need to do. Also another question just wondering how big our the factory rotors for a 94 GT? just wanna know so i can just imagine how nice the bigger ones will look.

 

[S/CBlack95GT]

Front rotors at 11.25 and the rears are 10 inches I believe. I think the kit has everything, although a larger master cylinder like that on the Cobra is usually recommended.

 

[emcobra]

http://www.corral.net/Tech/Suspension/CobraBrakes/CobraBrakes

Nice write up the project I have been wanting to get those too.
Pics when finished !

 

[FordStang]

awesome write up! I see someone has mentioned about the bigger brake master cylinder. Where can i find a new one and how much do they run? Thanks
Also is there a chemical i can dip my new rotors in so they do not rust up and look like **** before i go to install them??

 

[Slow5.0]

http://www.corral.net/Tech/Suspension/CobraBrakes/CobraBrakes

Nice write up the project I have been wanting to get those too.
Pics when finished !

Nice info

 

[FordStang]

talked to a mechanic and he said i need a cobra Booster and Master Cylinder once i install this brake kit? This true??

 

[Mrgreen94gt]

The kit has everything that is needed. I just got the front kit from them earlier this week. Everything went on in about an hour, but there were some complications with bleeding the brakes. Didn't get all the air out until the next day. Speedbleeders would have helped out a lot.

What surprised me the most is how light the calipers are compared to the stockers!

 

[DaveB]

I got the Cobra front brakes and let me tell you, you are going to love them . They are great for the money and one of my favorite mods so far, if not my favorite. Here are some pictures I have that show the size of the brakes compared to my 03 Cobra wheels.

 

[FordStang]

sweet i got the front and rear kit though, so i still dont need the Master cylinder? or Booster?

 

[zenboy99]

How much was the set shipped?

How much does the Cobra master cylinder usually cost?

 

[maypo59]

I did mine with cobra 13" in the front and Baer 13" in the rear, didn't change the master cylinder and no problems at all. I did change to all SS lines also. Pics of the brakes at my cardomain site thingy...

 

[moneypit94]

price please?

 

[Mrgreen94gt]

The front kit is about 435.00 shipped from PPI (www.mustangparts.com). More if you want stainless lines, I just used the rubber ones.

I think the Baer rear kit is around $259 w/drilled rotors. I think there is a plain rotor kit for less.