How do you multi-quote like you did??
210-215 is not overheating and is actually perfectly normal for after idling for 15 minutes. 15 minutes is a long time. You're fine.
I not know what the factory spec is, if there is one, but personally would not be concerned until 240*+ and it's a problem when it starts to overflow.
). You can make some inferences about what was deemed acceptable from those specs.

Some parameters from Ford. The puter starts pulling timing at about 226*F and IIRC, it shuts the AC off at 242*F.
94-95 fans have low speed come on/off at 208/200*F. High is 226/220*F (). You can make some inferences about what was deemed acceptable from those specs.
Those temps are nice for economy and emissions but not for our old stangs, nor aluminum heads. Nor is it really idea if running a 180* t-stat in an effort to phase shift all operating temps (across the board).
Optimal coolant temps are 190-210*F. I hate seeing more than 195*F personally (partly because I like lots of fudge factor when it's 115*F outside).
FWIW, a HD fan clutch and metal repalcement fan blade work well (what I run on the fox. Poop Dawg is the only guy I can think of whom had issue with this set-up for some reason). However, you're in over 100 beans for both. For that money, you could get the Taurus fan working with a good controller that shouldn't crap its pants (unless your fan motor was really resistive and that was why you were melting wires).
Have you ever tried letting it idle. Then put a huge box fan (or one of those contractor fans with the slit-sized discharge nozzle) in front of the opening(s) in front of the car? If it stays cooler like this, you know you have a fan issue.
Good luck bud. You're like the Bottomlesspit (Ken) of cooling fan issues.![]()
![]()


1) Usually my buddies cars run significantly cooler than mine. None of them have working A/C and thus the condensor is gone.
2) The efan will cause me to have to purchase a 3G alternator and a DCC controller- I know someone gave me some schematics on how to set up a light to tell if the fan is off or on. It'll take me a long time to buy this stuff.
3) I'm still utterly lost as to how the wires melted on the fan. I think I'll copy my friend's set up, except I'll use a DCC controller. Maybe the car won't catch fire if the wires melt again.
You want the middle of a given fan blade to be under the outer edge of the shroud (half covered, half exposed). Getting the fan oriented with regard to the shroud is pretty important.4) I have a 16" (i think) flex fan I was using, but the spacer for it kept it short of getting all the way into the shroud. I bought a longer spacer so maybe that would work. If the flex fan was closer to the radiator and more "inside" the fan shroud.![]()
you could hard wire the Taurus fan in - just for a testing session to see if it would otherwise fix your issue. If so, you know that with proper fan control and wiring gauge, you should be set. If you do this, use FUSED 10 or 8 AWG wires. 210-215 is not overheating and is actually perfectly normal for after idling for 15 minutes. 15 minutes is a long time. You're fine.
210-215 is not overheating and is actually perfectly normal for after idling for 15 minutes. 15 minutes is a long time. You're fine.
