Paint on my Intake?

newjersey

New Member
Oct 18, 2007
13
0
0
Recently had my upper cobra intake sandblasted to get rid of some paint , I think im going to clear it , but i was wondering if i should use a high temp. clear spray paint or a regular clear... Not even sure if they make a high temp clear? Also i think the inside of the trottle body opening was sandblasted a little bit will this hurt any kind of air flow or performance might be a supid question but let me know Thanks Guys ...
 
Recently had my upper cobra intake sandblasted to get rid of some paint , I think im going to clear it , but i was wondering if i should use a high temp. clear spray paint or a regular clear... Not even sure if they make a high temp clear? Also i think the inside of the trottle body opening was sandblasted a little bit will this hurt any kind of air flow or performance might be a supid question but let me know Thanks Guys ...

Regular clear will peel for sure. I would sand it down to a nice polish. There are some good threads on here on how to do it. I've never seen high temp clear...:shrug:
 
yeah there's high temp clear. you can get it anywhere you can get high temp paint. you should paint the intake too, not just clear it. get a high heat aluminum paint and high heat clear. here's what mine looked like after i painted it this past summer. still looks just as good too! :nice:

DSCF0696.webp


DSCF0695.webp
 

Attachments

  • DSCF0696.webp
    DSCF0696.webp
    31 KB · Views: 249
  • DSCF0695.webp
    DSCF0695.webp
    43.2 KB · Views: 209
yeah there's high temp clear. you can get it anywhere you can get high temp paint. you should paint the intake too, not just clear it. get a high heat aluminum paint and high heat clear. here's what mine looked like after i painted it this past summer. still looks just as good too! :nice:

DSCF0696.webp


DSCF0695.webp

This looks good. I'll remember this when I do mine. Chrome is just too hard to take care of.

Jason
 

Attachments

  • DSCF0696.webp
    DSCF0696.webp
    31 KB · Views: 267
  • DSCF0695.webp
    DSCF0695.webp
    43.2 KB · Views: 227
i used duplicolor DH 1606 High Heat Aluminum and DE 1636 Clear. the aluminum SAYS it can handle up to 1200*F and the clear can handle up to 500*F. you can get them both at an autoparts store that sells paint. autozone, oreillys, advanced, etc.
 
i would paint it silver and then clear it as stated above, and realistically, you really dont need high temp on the upper plenum...think about the paint on your car body, sometimes in the summer you cant even touch the hood or the roof cause its so hot when your cars been sitting in the sun. It doesnt hurt to use it, but its not really necessary.