For years, my 67 convertible had a rear quarter trim panel (the metal part) from a 65-6. I swapped it for a 67 about a year back, but I need to paint it to match the interior.
I'm in the process of removing some surface rust, and that is going well, though suggestions are always welcome.
My bigger concern is not smoothing out the crinkle finish/texture on the metal. I'm planning on doing several very light coats of the rattle can, and I'd be most grateful for additional tips, especially since the pro who painted my doors rendered them smooth, which makes me think keeping the crinkle is at least somewhat difficult.
I'm in the process of removing some surface rust, and that is going well, though suggestions are always welcome.
My bigger concern is not smoothing out the crinkle finish/texture on the metal. I'm planning on doing several very light coats of the rattle can, and I'd be most grateful for additional tips, especially since the pro who painted my doors rendered them smooth, which makes me think keeping the crinkle is at least somewhat difficult.