paxton intercooler with vortech blower

[swl987]

The paxton kit comes with 3 pieces of duct work. One long one with a 90degree bend, a short one with a 45degree bend, and a longer one with a 45degree bend. Which pipe is the one that connects to your original vortech discharge pipe? The one that you weld your bypass into. The pipe with the 90degree bend, it has a bung on it, what connects to that?

 

[96SCstang]

i am not a 100% sure but i believe the bung is for a IAT temp sensor. hopefully someone with this setup will chime in and be of some help

 

[spederman]

are u running blow thru or draw thru setup? u will also end up cutting the orig vortech discharge tube to make it fit

 

[swl987]

are u running blow thru or draw thru setup? u will also end up cutting the orig vortech discharge tube to make it fit

not sure,explain

 

[spederman]

Is your MAF before the supercharger or after it?

 

[swl987]

are u running blow thru or draw thru setup? u will also end up cutting the orig vortech discharge tube to make it fit

maf is before, I have draw through. I found out what that means.

 

[spederman]

ok, i have a blow thru. i'm not sure how you would route the piping then since we have different setups. Sorry i couldnt be more help.