PCV Valve

savegoodautonfg said:
http://www.latemodelrestoration.com/iwwida.pvx?;item?item_no=LRS-6631K 1&comp=LRS

I think what i need is a new pcv valve.

People have told me i also need a screen and grommet. now where are these located and how do you replace the screen and gromet. When you pull up on the pcv hose, from there waht do i do?

Also to add to my post in the latemodelrestoration link it does'nt show the actualy valve i don't think. im confused. look at this one?

http://www.latemodelrestoration.com/iwwida.pvx?;item?item_no=EV111 1&comp=LRS
 
That's the valve with adapters to accomodate different fit, you will need the grommet and screen as well. Grommet and screen are located on the lower intake by the firewall..easy remove and swap.
 
You can go to a regular old parts store and get the PCV valve. It will come with a black plastic top on it. Just use a lighter to heat up the plastic and then pull it off of the metal base. Volia, there is the PCV that fits your application (or ours I suppose)

The grommet is what the PCV fits into. They get old and brittle so it's easy to swap out a new one.

The screen will require a pick because it's deeper in the opening (where the PCV goes) A long tool with a hook usually does the trick to pull it up and out.

I am unsure if you can get either the screen or grommet from the local parts store. maybe NAPA, but I am not sure.
 
Yep - I had better luck with the OEM grommet and PCV seating than I did with a parts store PCV.

Good call - do replace all 3 items. If needed, the screen can be sourced from the parts store (if you're going to have one item not be Motorcraft, that's the one to go cheap on).
The Ford grommet and PCV valve fit can be so tight that the last set I installed (on a 94), I had to silicone spray the inside of the grommet to allow the PCV valve to slide in :nice:
 
ARTTII said:
My PCV and grommet fit kind of loose, is this a problem? Will it create a vaccum leak or is it ok?

Thanks
It can be - that's why DTT and I posted and feel the way we do (the valve can pop out, or just allow an oily seeping mess to creep out of the grommet).

Good luck.
 
Realmongo said:
I got my new screen at the local Advance Auto parts. Funny thing was the counter people had never seen one before.
I'd note that some stores refer to the screen as a breather - if you dont ask for a breather, they dont show a 'screen' in the computer. :rolleyes: