I know I'm not in the modular crowd, but after doing some research on Atlanta-area performance shops and suspension installs, I came across a good post you did a couple months ago. My question is: If you did use T&J, how was your experience there and do you remember what the cost was for the installation.
Basically, you were referred to T&J in one thread and it appeared that you were going to use them to install the Bullitt Kit, C/C plates, and subs. I am looking to have similar items installed (Bullitt Kit w/sways, MM C/C plates, and Energy Suspension's complete bushing kit). I also hope they can do the alignment, because I've heard that "chain shops" don't know crap about aftermarket C/C plates and some won't touch a car with them.
I'm going to call T&J later this week, but thought I'd get some feedback from you since your mods are so similar. I did read that you had issues with the Steeda C/C plates, but I haven't heard anything negative about MM plates, particularly with hood clearance.
Thanks in advance. BTW, I've only heard good reports about T&J, so I expect your experience would be the same.
Basically, you were referred to T&J in one thread and it appeared that you were going to use them to install the Bullitt Kit, C/C plates, and subs. I am looking to have similar items installed (Bullitt Kit w/sways, MM C/C plates, and Energy Suspension's complete bushing kit). I also hope they can do the alignment, because I've heard that "chain shops" don't know crap about aftermarket C/C plates and some won't touch a car with them.
I'm going to call T&J later this week, but thought I'd get some feedback from you since your mods are so similar. I did read that you had issues with the Steeda C/C plates, but I haven't heard anything negative about MM plates, particularly with hood clearance.
Thanks in advance. BTW, I've only heard good reports about T&J, so I expect your experience would be the same.