I'm looking for a recommendation on a machine shop in the Chandler/Tempe/Gilbert area.
I have a 289 with ~15k miles on it that I had built about 16 years ago. Wrecked the '66 about 14 years ago. Jeeez has it been that long! Anyways....at the time it was fully redone with a mild Comp Cam, Hypereutectic pistons, etc.
I want to have it disassembled, cleaned up, check the parts for any problems and short block it so I can put it back in my '65.
I'm looking for someone reliable. I could go through the phone book and bbb.org, but that doesn't tell me too much. All suggestions/recommendations are appreciated!
Thanks in advance.
I have a 289 with ~15k miles on it that I had built about 16 years ago. Wrecked the '66 about 14 years ago. Jeeez has it been that long! Anyways....at the time it was fully redone with a mild Comp Cam, Hypereutectic pistons, etc.
I want to have it disassembled, cleaned up, check the parts for any problems and short block it so I can put it back in my '65.
I'm looking for someone reliable. I could go through the phone book and bbb.org, but that doesn't tell me too much. All suggestions/recommendations are appreciated!
Thanks in advance.