pics of exhaust around panhard bars...

GTA_V6_Mustang said:

i dont like dumps

Click to expand...

x2. i had dumps and couldnt stand inhaling fumes the whole damn time

StadEMS3 said:

nmcgrawj said:

There's subframes that let u run side exhaust.

Click to expand...

Where? I've looked...

Click to expand...

Not hard enough


Spintech makes a side exhaust kit....they also make the subframes that are knotched for it.


Check you tube for a clip. I put one up....same username.

nmcgrawj said:

There's subframes that let u run side exhaust.


Or run through the floor subframes. Thats my plan.

Click to expand...

or you could have some custom make it for you like i'm in the process of doing right now.

ProKiller said:

or you could have some custom make it for you like i'm in the process of doing right now.

Click to expand...

im always an advocate of having it custom done rather than ordering the subframes. Pics? or

Sorry, that was directed at ProKiller....

Are your MM sfc's full length? If they're not full length, you can still run side exits. You just don't use a side exit muffler, and place a 90 degree bend immediately after it exits the muffler.

If my exhaust was completed, I'd show you

nmcgrawj said:

im always an advocate of having it custom done rather than ordering the subframes. Pics? or

Click to expand...

:OT:I defineatly will once I get it all made Nate. I dropped off the mufflers this morning. Ended up going with DynoMax Bullets. less expensive than the borla stingers and the same size. We'll see how it pans out.

ProKiller said:

:OT:I defineatly will once I get it all made Nate. I dropped off the mufflers this morning. Ended up going with DynoMax Bullets. less expensive than the borla stingers and the same size. We'll see how it pans out.

Click to expand...

tick tock tick tock......

thethirdeye88 said:

anybody have any pics of exhaust going around panhard bars?...im wondering how the exhaust will fit...thanks...

Click to expand...

This seems like you will have to take it to the muffler shop and have them "Fit" it, I only have the axle braces and my exhaust does not and did not clear, Either i had to dent it or bend it different way to fit it, after minute of thinking i just went dumps, It looks little stupid and weird without tailpipes on saleen rear bumper but it needed to be done.

I can't even imagine tailpipes going around the MM panhard bar, I know it can be done but at a cost and fab job will be involved.

I don't have a panhard bar but do they really help or see a improvement on the street or drag racing? I have been thinking about it but never thought i needed it.

MM's panhard rod will fit the OEM exhaust fine. Last time I looked, MM lists the few aftermarket cat backs it will fit w/o interferance on their website. The addition is great for the street/road race applications but not really needed for drag racing applications.

GT