OKay, ive done numerous searches on which cam is ideal for my setup and have arrived to no conclusion... im actually more confused than when i started.... 
my setup is:
2001 Bullitt:
-4.6 bored and stroked to 5.0
-D1SC ProCharger runnin 17 lbs boost
-Ported Heads and Intake with oversized valves and upgraded springs
-3.90 - 4.30 gears (currently 4.30 with viper t-56, but might downgrade)
-built for drag racing, but definitely a weekend street warrior...
the cam i was currently running was a bitch to tune and had stalling issues... the specs were 540"x .540"x 225d @ .050"x 112 lsa
now, ive heard these arent ideal for my setup for the s/c setup i have and boost im running... i believe the the intake and exhaust duration is the same on my current cams, which i believe, may be causing my issues? i need more exhaust?
im looking into comp cams, and have contacted them and they recommended part #102200 which is the XE265H... isnt this cam for non PI heads which i do not have?
i guess im lookin now into the XE262AH or XE270AH... does anyone have a similar setup and have any comments? which cams are you running? i would like to hear some lope, but nothing too aggresive to where it gets old after driving a few hours in traffic....
thank you so much in advance!!! need to figure this out quick....
-pino
p.s. anyone have any sound clips of either cam?
my setup is:
2001 Bullitt:
-4.6 bored and stroked to 5.0
-D1SC ProCharger runnin 17 lbs boost
-Ported Heads and Intake with oversized valves and upgraded springs
-3.90 - 4.30 gears (currently 4.30 with viper t-56, but might downgrade)
-built for drag racing, but definitely a weekend street warrior...
the cam i was currently running was a bitch to tune and had stalling issues... the specs were 540"x .540"x 225d @ .050"x 112 lsa
now, ive heard these arent ideal for my setup for the s/c setup i have and boost im running... i believe the the intake and exhaust duration is the same on my current cams, which i believe, may be causing my issues? i need more exhaust?
im looking into comp cams, and have contacted them and they recommended part #102200 which is the XE265H... isnt this cam for non PI heads which i do not have?
i guess im lookin now into the XE262AH or XE270AH... does anyone have a similar setup and have any comments? which cams are you running? i would like to hear some lope, but nothing too aggresive to where it gets old after driving a few hours in traffic....
thank you so much in advance!!! need to figure this out quick....
-pino
p.s. anyone have any sound clips of either cam?
