Please help with Modifications!

srothfuss said:
I go with a 73mm C&L or similar for now (you can alway's resale them on eBay as you change things)

Thanks for replying srothfuss. Ok im going to buy the BBK 70mm Throttle Body. Now my question is for the MAF Sensor you said the C&L 73mm which sounds good to me but my question is for what size injectors. When i went on C&L site it asked me for what size injectors? And also what is the difference btwn the different MM's on the MAF sensor?
 
Answer to mm of MAF's: The size of all MAF sensors is read in milimeters (mm for short.) The stock size is 55mm and can be a choke point in the upper RPM range. 1 inch = 25.4mm or

55mm = 2.165"

73mm = 2.874"

Now on to Injectors: The EFI motor uses a fuel injector to spray fuel into the combustion chamber. There are different PSI ratings for injectors. The stock injector size in 19lbs. This is what you have and what you need to input on the C&L website.

Other sizes include but are not limited to:

24lbs
30lbs
42lbs
 
srothfuss said:
Answer to mm of MAF's: The size of all MAF sensors is read in milimeters (mm for short.) The stock size is 55mm and can be a choke point in the upper RPM range. 1 inch = 25.4mm or

55mm = 2.165"

73mm = 2.874"

Now on to Injectors: The EFI motor uses a fuel injector to spray fuel into the combustion chamber. There are different PSI ratings for injectors. The stock injector size in 19lbs. This is what you have and what you need to input on the C&L website.

Other sizes include but are not limited to:

24lbs
30lbs
42lbs

Thanks for your help but i meant by the question i asked like why not 78mm like what is the difference... can it not be a certian mm to fit or something?
 
The MAF sizes are just measured in milimeters. Anything larger than 76mm will cause you problems when you try to hook it up to the stock rubber flexi tubes.

Haven't used Mac TB's before...
 
I'd stick with the BBK on the throttle body choice. As long as your mass air meter is larger than your throttle body, you should be alright. The 73mm should be large enough for any street-driven 302 that doesn't have nitrous or a blower, BUT I'd go ahead and spring for the 76mm. The power difference will be none if any and it should be in favor of the 76mm. Plus due to the size, the 76mm will flow more and allow for a larger horsepower potential before the meter reaches it's maximum potential. Hope this helps, and if anyone see anything wrong with this post feel free to interrupt.