Please Quick Answer

[damystikal69]

Iv'e got my car at Top Dead Center. I put the distributor in. Wheres the rotor sit? Is it torward the number 1 cylinder or is it the number one on the cap?

 

[aleborjas]

the number one on the cap, facing the intake

 

[giddyup306]

Under the 1# on the cap.

 

[damystikal69]

so,the rotor should be at 12:00 postion?

 

[jrichker]

Putting the distributor back in is fairly simple. Pull #1 sparkplug, put your finger in the sparkplug hole, crank the engine until you feel compression. Then line up the TDC mark on the balancer with the pointer on the engine block. Align the distributor rotor up with the #1 position marked on the cap, slide the distributor down into the block, (you may have to wiggle the rotor slightly to get the gear to engage) and then note where the rotor is pointing. If it still lines up with #1 position on the cap, install the clamp and bolt. If not, pull it out and turn 1 tooth forwards or backwards and try again. Put the #1 spark plug back in and tighten it down, put the clamp on the distributor, but don't tighten it too much, as you will have to move the distributor to set the timing. Note that if it doesn't align perfectly with #1 position, you can turn the distributor until it does. The only problem is that if you are too far one way or the other, you can't turn the distributor enough to get the 10-14 degree optimum timing range.

At this point hook up all the wires, get out the timing light and start the engine. Set the timing where your car runs best. Don't forget to disconnect the SPOUT jumper connector when you set the timing, and plug it back in when you finish.

 

[86bluecobra]

if after you do that and the car doesn't start it is because dizzy is 180 degrees out. sometimes people don't get tdc on the compression stroke. jrichker gives you all you need to know. i have seen the Ford engineers put a dizzy in 180 degrees out. it happens to us all.