polishing brackets

83Mustang427TT

New Member
Jan 18, 2006
162
0
0
Ok guys now I have heard and seen polished brackets like the P/S bracket ...so I tried to do it myself ..well besides the fact that my hand hurts heres a pic ..I still have a lil bit of cloudyness? in it how do I get rid of that?
 

Attachments

  • 100_0202.webp
    100_0202.webp
    8.7 KB · Views: 226
pb_paulie_b said:
What did you use? Cloudiness is common with this piece. It because of the sad quality of the metal.
Here's one that I did...PB

Yup...like he said, that piece will be a little cloudy due to the metal quality. You might want to try tripoli again, then re-buff it with the white compound to bring out the shine.
 
pb_paulie_b said:
It because of the sad quality of the metal.

These sort of surface imperfections are common in casting grade aluminum that has a lot of impurities added to aid in flow (filling the casting) & release from the casting (lubricants). It is in no way indicative of the quality of the metal.
 
Cougar5.O said:
These sort of surface imperfections are common in casting grade aluminum that has a lot of impurities added to aid in flow (filling the casting) & release from the casting (lubricants). It is in no way indicative of the quality of the metal.
I beg to differ. It's basicly pot metal. The cheappest of the cheap.
 
I normally start with a real good cleaning of the part.
Then the sanding begins. I use a 6 inch random orbit sander and a expander wheel where ever possible, but much has to be done by hand.
I go from as low as 80 grit to as high as 600 in extreme cases.
Example. I'll go in stages from 80 to 100 to 180 to 220 to 320.
After all that the buffing part is easy. I normally start with a 6 inch sisal wheel/ black or brown compound on a 3/4 hp buffer and end with a spiral sewn buff and blue or white compound.
You can take an ugly piece of aluminum that someone took a grinder to...
DSCF1985.webp

And make it look like this...
DSCF2003.webp
 
pb_paulie_b said:
Then you already know it's cheap.

It may be cheaper than billet, but you can't cast pure aluminum - it's way too sticky. Machined billet brackets would be way too expensive for a car maker.

BTW polishing novices - DO NOT take off too much material when working with castings - if you do you may expose small air bubbles just below the surface of the casting and they don't look good at all once exposed.

I got a nice 8" grinder and with some spiral sewn buff wheels & a few compounds I can get a good shine once the surface is smooth enough to start the final polishing (sanding described above by pb_paulie_b).
 
LOL, when i saw paulie polish stuff a while back, it inspired me to go out and buy some stuff, liek 2 nights ago i got some compounds and some wheels for my dremel and started polishin some random things, it actually works pretty good, i was using the red compound, i think its for high gloss.... not positive. The stuff the paulie does is amazing.... im gonna go buy some wheels for the table grinder thing.

-AJ
 
Just keep at it and you'll learn the tricks of the trade..I use 3" buff wheels on a high rpm grinder with white rouge...never usually go beyond 320 sanding and a quick scrub with 400 and a palm sander. For really good finish try to keep your movements either back and forth or up and down...not circles, this includes both sanding and buffing. Some pcs can only be taken so far, and lighting will have a huge impact on the overall appreance so don't be overy concearned if your's is not perfect under certain lighting...it will neveralways look perfect.