• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Popping noise from front while turning

  • Thread starter Thread starter sunil6784
  • Start date Start date Mar 5, 2006

sunil6784

Member
Mar 31, 2005
620
0
18
Boston, MA
Mar 5, 2006
#1
  • Mar 5, 2006
  • #1
What a week...wrecked my daily driver because of the snow. No one's at fault, and the car didnt have collision on it. So i'm forced to put the mustang back on the road. It seems to be running right, I changed the oil and filter and fixed my EGR problems with a new valve. There is a popping noise coming from the front right while turning. It doesn't have to be rack to rack. Sometimes it will creek a little, sometimes it will pop. Any ideas what this could be? I know noises are hard to diagnose on the internet. Any help would be good. Thanks guys.
 
9

92Patrol5.0

Founding Member
Sep 20, 1999
1,076
1
38
Cedar Rapids, Iowa
Mar 5, 2006
#2
  • Mar 5, 2006
  • #2
My first guess is based on a similar situation I had. Mine happened to be the stabilizer bar bushings were junk and as the car would lean when going into a turn the bar would move and the bushing would bind and make a pop. Could also be a tie rod end or something like that also. Get under the car and check out those areas and see if anything is loose or has bad bushings.
 

bill302

Active Member
Nov 2, 2005
2,131
1
46
alabama,gadsden
Mar 6, 2006
#3
  • Mar 6, 2006
  • #3
tie rod ends or ball joints would be my best guess....
 

srothfuss

Last night I stabbed the same guy 7 times in a row
Oct 17, 2004
1,796
3
0
Woodward Ave.
Mar 6, 2006
#4
  • Mar 6, 2006
  • #4
If it's cold where you are at in Mass I would guess dry bushings that are cold and don't want to compress. But you really need to check the ball joints because they start to warn you just the way you are describing.
 

jaidedeye

Member
Apr 4, 2004
627
0
16
Goldsboro nc
Mar 6, 2006
#5
  • Mar 6, 2006
  • #5
id say ball joints..mine made popping noises while turning...
 

sunil6784

Member
Mar 31, 2005
620
0
18
Boston, MA
Mar 6, 2006
#6
  • Mar 6, 2006
  • #6
It does it in the summer as well. Also, i should have added, it is most audible when the car isn't moving. I'm not sure if it happens while the car is moving, I might just not be able to hear it over the exhaust.
 

Zero_chance

Founding Member
May 29, 2001
1,244
7
59
Maricopa, AZ
Mar 6, 2006
#7
  • Mar 6, 2006
  • #7
My first checks would be the ball joints and outer and inner tie rod ends. Theyre the biggest safety issue whereas a dried out bushing is just annoying. Trust me, I had a ball joint blow out in my stang and it trashed my rim. And if it is a ball joint, dont listen to people that say you have to replace the whole control arm. Ford USED to do that but then they issued a TSB in the early
90s I believe it was stating that its not cost effective to replace the whole arm (duh!) and to start replacing just the ball joint.
 
You must log in or register to reply here.

Similar threads

G
Electrical Getting good ground in 1991 Fox Vert for amps - getting popping noise when I turn on the lights?
  • gvanginkel403
  • Apr 11, 2026
  • Fox 5.0 Mustang Tech
  • 2
Replies
20
Views
877
Fox 5.0 Mustang Tech Jul 21, 2026
gvanginkel403
G
Engine Popping noise in the intake. Frustrated still.
  • esteban31065
  • Apr 6, 2025
  • Fox 5.0 Mustang Tech
Replies
15
Views
1K
Fox 5.0 Mustang Tech May 23, 2025
gkomo
S
Engine Stalls when downshifting/coasting
  • Scott_S
  • Nov 5, 2025
  • Fox 5.0 Mustang Tech
Replies
11
Views
914
Fox 5.0 Mustang Tech Nov 6, 2025
Mustang5L5
B
Where to go from here on my build…
  • B0udreaux
  • Jul 14, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
8
Views
467
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jul 18, 2026
AeroCoupe
Fox Ideas for Theft Deterrence in Storage
  • Clutchfork
  • Nov 6, 2025
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2
Replies
38
Views
2K
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Dec 1, 2025
91AOD5.0LX
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?