Port/Polishing stock throttle body?

[jas142]

How would I go about doing it? Tips/suggestions? Thanks

 

[lightblade]

i dont think u can really port the tb only polish , u could p &P the upper intake plenum though which connects the tb to the intake manifold

 

[tomustang]

there NO point in doing it.

 

[jas142]

How would I go about porting/polishing the plenum, are there any how-tos? Thanks

 

[tomustang]

search in the forums, i don't know if there is a how-to yet, but i found where to port my upper intake in 5.0 mustangs and super fords mag. they were showing where a company ported the plenum.

 

[Darkhorse845]

I would do a search.I don't think it is
worth doing!

 

[gearhead81a]

re: porting throttle body.

Honestly its really not worth porting the stock throttle body. You arent even really notice a differece at all either. personally i would just look into the accufab 70mm throttle body and also a c&l mass air. With doin those simple bolt ons you will smooth out the power across the band and will equal fast et's. good luck bro and let me know how you do.

 

[billyfe390]

personally i would just look into the accufab 70mm throttle body and also a c&l mass air.

Thats poor advice.

Unless youve got a blower an aftermarket maf is not needed.