Power Combo

OVRSTR89

New Member
Aug 19, 2005
2
0
0
If i run the trick flow track heat kit with my 347 stroker 70mm throttle body and 190lph fuel pump what injectors should i run and at abought what fuel pressure would be a good starting point. I know on all other injected cars run 50 to 60 psi and that is normal. But i figure the injector size if needing to be larger may be a lower pressure like 40psi. Thanks any information is appreciated. :cheers:
 
I would suggest running 24lb injectors. This is assuming the power output will be about 300hp. If you have plans of boost in the immediate future then 30lb may be more appropriate, maybe bigger depending on boost levels.

I did use an excel calculator that I wrote to come up with this (I am not just making up numbers). If you would like to see it post your email or pm me, this site is not friendly to tables and it is a real pain to format it into Word. If you are not familiar with excel though it may just be confusing.


The fuel pressure should be fairly close to 40psi. I would set it to 39psi and try to tune from there. You just have to get close enough to correct so that the computer can adjust fuel ratio with injector duration.

The Ford systems seem to be about 39psi, other makes might go 50-60, but not many Mustangs should need that much pressure. Maybe very high compression or boost?

Come back if you still have questions

Good Luck
jason
 
Without reading the other posts I'd say 36's or 30's maybe. It depends on how much cam you end up with. If you end up with big high reving cam you might be right between 30-36. I guess it depends on your compression ratio and the total HP your gonna make. How much porting....etc. etc.
 
Anyone have a hp estimate from a dependable surce for this combo. The only formulas I have found for determining injector size are based upon hp levels. It's kinda tough to know the power level without putting the motor together and hitting a dyno.

What is the advertised power for the TrickFlow kit? Even if they only supply numbers for a stock 302, that would be fine.

I would love to run the numbers for you, but I need some power estimates first.

I agree that the TrickFlow cam may not be enough for the stroker, but I don't have any recommendations at the moment (I am just getting into cam design as of last night).

:cheers: :cheers: :cheers: :cheers: