power window help

[speedfreakzx9r]

i went to put my window down today and when it went down into the door it didnt stop.it was like the window motor kept pulling it down into the door. then i put it up and it wouldnt stop itself.anyone know what part in the door would cause this. also my heat and air only blow out the defrost no matter what setting i put it on. i was wondering if there was a vaccum line i could look at or something. thanks

 

[cjones]

the vacuum line is on the passenger side of the engine compartment by the firewall.

i'll get back with the electrical

 

[cbarr300]

yeah, that vac line is famous for coming off....at least on mine.

 

[cjones]

does it stop when you release the switch?? if so, check the upper limiting upstop.

for the down, does it stop just the motor doesn't stop?? if so, check the One Touch Window Down Module. it's in the drivers door. the Y and R wires go to the motor.

 

[speedfreakzx9r]

when you push the switch for it to go down automatically once it gets down inside the door the motor is still running and the window is jumping around inside the door and i have to hit up on the switch.

 

[cjones]

it's probably the One Touch Window Down Module inside the door. it's suppose to cut power once it comes into resistance.

 

[speedfreakzx9r]

thanks. im going to try to tackle these problems this weekend

 

[izeaha]

i had the same problem with the heat and air. but on my 94 gt the vacumm leak was coming from the drivers side on the fender. their is a vacumm line connection their.