Hey,
Shifters are super easy to install.
Just takes a time.
Heres the instructions on how to install the pro 5.0 shifter.
http://pro50shifters.meridian1.net/default.asp?S=E3&Document=EASY+install+procedure&NID=1448600
Another shifter you might want to consider is the Steeda Tri-Ax shifter.
Most people like either the pro 5.0 or the Tri-Ax, both of them are great.
Shifters are super easy to install.
Just takes a time.
Heres the instructions on how to install the pro 5.0 shifter.
http://pro50shifters.meridian1.net/default.asp?S=E3&Document=EASY+install+procedure&NID=1448600
Another shifter you might want to consider is the Steeda Tri-Ax shifter.
Most people like either the pro 5.0 or the Tri-Ax, both of them are great.
well first off, if thats your mustang in that pic under your name....its a little more complex then those instructions show. I have the shifter that you are inquiring about and i thought it was just 4 bolts, bam, bam,bam and im done. However i had to take out the stereo, remove the center console, the peice underneath the steering to get to the back 2 allen bolts, because you cannot get to them due to the plate on the shifter. Not incredibly hard to install, just make sure you have the patience and about 1-2 hours to do this.
It is easy. You do not need to remove your console. Just use some patience and extensions. 1/4 in. drive ratchets work well.
www.mustangworld.com has a nice color pictured writeup on a Pro 5.0 install under their writeups. Check it out
Use some hightemp RTV to seal the base of the shifter to the transmission. Tight snuggly.
Set your stop bolts correctly as outlined in the mustangworld writeup.
Make sure the plastic cup is still in the tranny area when you remove/replace the shifter ball in the transmission.
www.mustangworld.com has a nice color pictured writeup on a Pro 5.0 install under their writeups. Check it out
Use some hightemp RTV to seal the base of the shifter to the transmission. Tight snuggly.
Set your stop bolts correctly as outlined in the mustangworld writeup.
Make sure the plastic cup is still in the tranny area when you remove/replace the shifter ball in the transmission.