Prochamber Help

S

Stang2003GT

Member

Jul 7, 2003

254

0

16

Dec 25, 2003

#1

• Dec 25, 2003

• #1

My parent finally allowed me to ditch my cats and got me a Prochamber for Christmas and the only catch is I have to have a muffler shop install it. So do I still need to get the stud and Gasket or just intall the Gasket that MAC sent with the midpipe and let them mess with the stud or should I just go buy the Gasket and Stud?

Also How do the MILs get connected?

 

S

Stang2003GT

Member

Jul 7, 2003

254

0

16

Dec 25, 2003

#2

• Dec 25, 2003

• #2

Stud Number

Whats the Stud number for the passsengerside exhast manifold to Midpipe

 

Redfire03GT

New Member

Sep 10, 2003

395

0

0

Newark, CA.

Dec 25, 2003

#3

• Dec 25, 2003

• #3

People have complained about the gasket that comes with the ProChamber but, I used it and it's been fine since the install. As far as I can tell, as least. MILs attach to the rear 02 sensors between the sensors and the harness, it'll make more sense when you get under the car.

 

2k2SilverBullet

Founding Member

Jul 30, 2002

356

0

0

Missouri

Dec 25, 2003

#4

• Dec 25, 2003

• #4

i have it no problems at all. i didnt need new studs. reused the factory ones. great horsepower gain 3000rpm+

 

jamathi

Founding Member

Aug 19, 2002

87

0

7

Chicago,IL

Dec 26, 2003

#5

• Dec 26, 2003

• #5

Stang2003GT said:

My parent finally allowed me to ditch my cats and got me a Prochamber for Christmas and the only catch is I have to have a muffler shop install it. So do I still need to get the stud and Gasket or just intall the Gasket that MAC sent with the midpipe and let them mess with the stud or should I just go buy the Gasket and Stud?

Also How do the MILs get connected?

Click to expand...

I needed the studs but only for the drivers side, not passanger side. The reason you need the studs is because in the center of the bolt there is larger non threaded area which leaves a gap for air to leak. The studs come in a kit from NAPA. Part number 600-1819. They come with nuts also. As far as the ghasket goes I say go for it. It should not cost to much from ford and it is only 1 gasket you need ...only for the passanger side. I am pretty sure yopu will need Mil's...only for the 2 rear o2 sensors. I have them on mine and no check engine light.

 

R

RacerGT

Founding Member

Jun 28, 2002

2,371

0

0

St. Charles, Missouri

Dec 26, 2003

#6

• Dec 26, 2003

• #6

Good luck finding a shop to install this, most shops won't touch it. You'll have to use a performance shop to do it.

 

2k2SilverBullet

Founding Member

Jul 30, 2002

356

0

0

Missouri

Dec 26, 2003

#7

• Dec 26, 2003

• #7

i had a local muffler shop install mine....no problems yet