Progressive vs non progressive springs.

JohnyD05

Founding Member
Mar 17, 2002
417
0
0
Massachusetts
I am considering the maxium motorsports sport box, i belive it comes with new springs. and i was wondering what is everyone opinion on wether to get progressive or non progressive springs, anyone experience in there cars? advantages, disadvantages?
 
Basically...
Progressive springs rate increases as they are compressed. (Your lowered car wont squat to the ground when weighted down)..

Normal springs (like stock) have the same resistance until full compression.


This is why its safe to cut stock springs without fear of hurting the rate.
 
Progressive springs will work your shocks more than a linear spring will. By that, if your springs are progressive the rate gets higher as it compresses, therefore the shock has to work harder to keep the spring from bouncing more. The advantage of progressive springs are of course a better ride when not being pushed but will be stiffer when put through the loads of force from cornering. Progressive springs will also help to eliminate the bottoming out the spring when it is compressed to the maximum extents of travel.

A top grade shock/strut with a wide range of compression and rebound control for the different rates that are encured from a progressive spring going through its travel will be required if that type spring is used.

The advantage of linear springs is more constant spring rates while cornering and the effects of the shocks acting with it are more equal during the changing of forces applied to the springs.

For me, I have found that a linear spring is more predictable and has somewhat better (more constant) feedback while pushing your car to the limits during cornering.

I could not find a linear spring front and rear combo for my Mach1 that had the spring rates I wanted. I have the linear up front and the progressive with a very small difference in rate change on the rear. I have found that when at full tilt in a corner the rear will give me a slight pogo effect even with my shocks set on the full hard setting when I encounter a dip in the road surface.
 
JohnyD05 said:
what linear and what progressive rate springs do you recomend with a decent drop but not too much?1 if you know what i mean. what do you have on your mach 1, hotrodnut?

I have linear 700 pounders up front and progressive 275-300 in the rear. You can look in my Garage to see the amount of drop it gave my Mach1 (picture with the black Racing Sparco wheels in my Garage photos).

I was actually looking for more around 650# up front and 300# in the rear to help get rid of the heavy understeer the Mach1 has from the factory with a 1.25" drop up front and 1.50" drop in the rear. What I have gave me close to 1.25" on all 4 corners but recently I installed Steeda's adjustable weightjacker lower control arms and I dropped it another .25" in the rear (picture with stock Mach1 wheels in my Garage photos). The dimensions I quoted are from the standard Mach1 spring ride height which is around .50" lower than the standard GT springs to start with.