I dont know if any of you remember but i been posting on and off about a project i am all tied up in. I have a 99 V6 with an auto trans, its at 90k and getting craped out...so i decided to go with a 4.6 and a manual trans, so i baught the fallowing parts..
-98 4.6 GT motor (complete with 60k)
-2001 T-45 with 26k (needs shifter and clutch fork/pivot ball)
-i have 99+ fuel rails
-BBK U/D pullies (power plus series)
-BBK o/r X and mac flopaths catbacl
-2001 4.6 wiring harness
-99 gt 5speed computer
-99 GT speedometer cluster
-5 speed pedal assembly
-clutch cable and qudrant
-throttle cable
-shifter boot and console
-Coil on plug units
-4.6-t45 dirveshaft for 96+ Gts
i think thats all that i have got for right now, for those of you who dont udnerstand, i am updating the 98 motor to 99+ standards (PI stuff will be a few months down the road), so i just need to know if i am missing anything before i start the install? any help, tips, or ANYthing at all will be much appriciated!
thank you!
Ryan
-98 4.6 GT motor (complete with 60k)
-2001 T-45 with 26k (needs shifter and clutch fork/pivot ball)
-i have 99+ fuel rails
-BBK U/D pullies (power plus series)
-BBK o/r X and mac flopaths catbacl
-2001 4.6 wiring harness
-99 gt 5speed computer
-99 GT speedometer cluster
-5 speed pedal assembly
-clutch cable and qudrant
-throttle cable
-shifter boot and console
-Coil on plug units
-4.6-t45 dirveshaft for 96+ Gts
i think thats all that i have got for right now, for those of you who dont udnerstand, i am updating the 98 motor to 99+ standards (PI stuff will be a few months down the road), so i just need to know if i am missing anything before i start the install? any help, tips, or ANYthing at all will be much appriciated!
thank you!
Ryan