PVC baffle on E'Bock lower intake?

[BYRDPE]

I purchased a used E'bock intake and it doesnot come with the PVC baffle installed.
Can I remove the one from my stock lower and install it on the E'bock?
I read that Edelbrock sends some type of pins to install the baffle on their intake.
Will I need these? If so,where can I get them?
If not what can I use?

Thanks

 

[NosPony]

Maybe try contacting the edelbrock company. They might beable to help.

When I put my Edelbrock intake on my gt I forgot my baffle and WOW it sucked a ton of oil. So before you put it on get one.

 

[tmoss]

I would just cut a new one from galvanized sheet metal - easier than try to pry out the stock rivets.

 

[stang22]

I would just cut a new one from galvanized sheet metal - easier than try to pry out the stock rivets.

My Typhoon didn't come with one either. I ground off the rivets on my stock lower and used that one. Worked like a charm.

Tim

 

[tmoss]

Then that intake doesn't have one either - gonna sell it? The guy buying might want one too. It takes about 5 minutes to make one from galvanized sheet metal.

 

[stang22]

gonna sell it?

Am I going to sell my stock intake? You lost me for a minute Tom.

Tim

 

[tmoss]

sometimes my communication breaks down - like ole Bill there......

 

[BYRDPE]

Thanks for the replies.
I misinterpretated what he said.
He meant I will need to install my PVC screen.

 

[HuebyStang94]

I forgot to put one in on my Eddy lower, and it sucks some oil up...... I've been trying to decide what I'm going to do. I found the part# for one at Advanced Auto, but haven't tried installin it yet. (intake already installed, doh!) I didn't think of making one myself....