Question About Injector Wiring.

Z28-STANG

New Member
Aug 28, 2004
7
0
0
The wife's car (89 GT) is having a problem starting. It is getting spark but, no fuel. I have checked the injector wiring and have found that both wires going to each injector has 12 volts. I was under the impression that only one wire had 12 volts and the other was a ground going back to the computer. Did I misread? Are both wires at the connector supposed to have 12 volts constant? If not is this a wiring problem or a computer problem? I swear this thing is getting closer and closer to being carbureted each day. :mad:
 
You are correct. The injectors get 12 volts with the key on (constant voltage) from the EEC relay. The computer uses pulsed ground to actiuate the injectors. It's easier for ground to be modulated by the puter for injector pulsewidth, etc.
 
You are correct. The injectors get 12 volts with the key on (constant voltage) from the EEC relay. The computer uses pulsed ground to actiuate the injectors. It's easier for ground to be modulated by the puter for injector pulsewidth, etc

So what would cause both wires to get constant 12 volts?
 
Z28-STANG said:
So what would cause both wires to get constant 12 volts?
The red wire on the injectors is energized anytime the ignition switch is in the Run position.

You will read 12 volts on the ground lead until the computer pulses and switches it to ground. That pulse is only a few milliseconds wide, so a voltmeter would never see it. You need a Noid light (available at most auto parts stores) or an osilloscope to see the pulse.

If you use a Noid light and don't see it flash, when you crank the engine with the ignition switch, then you have either computer or wiring problems with the 10 pin connectors.