Hello All, First post, so bear with me..
I am looking to start working on my project a little more in the spring.
I have decided to go and get a set of AFR 165cc heads, along with new push rods and roller rocker's. Right now I have about 1000 miles on a new short block 308 BBP with forged pistons/rods 9.5:1 (along with the modds in my sig)
Can some one tell me what the difference between stud/pedestal mount heads? If there is a benefit from one to the other I can buy a set of rr's to match the heads.
Also, do I have any other things to consider with the install of the heads other then the obvious, IE gaskets, fluid, torque specs, est..?
I am looking to start working on my project a little more in the spring.
I have decided to go and get a set of AFR 165cc heads, along with new push rods and roller rocker's. Right now I have about 1000 miles on a new short block 308 BBP with forged pistons/rods 9.5:1 (along with the modds in my sig)
Can some one tell me what the difference between stud/pedestal mount heads? If there is a benefit from one to the other I can buy a set of rr's to match the heads.
Also, do I have any other things to consider with the install of the heads other then the obvious, IE gaskets, fluid, torque specs, est..?