hey guys. the 65 is off to the chassis shop on sat. to get a 6 point cage and subframes put in. I had a chance to climb into a 68(?) chevy SS at the shop with a cage, and it was a tight fit getting between the doorbar/steeringwheel/seat bolster. And thats with that car having an aftermarket 13 inch steering wheel. Since its already hard to get in with the stock steeringwheel, its going to be darn near impossible to get in comfortably for myself (6'1, 190) and an amazing bending act to get my dad into it. (6'4'', 200+). So, does anyone have any suggestions for a quick release steering hub and steering wheel combo? I dont know about the steering shaft spline count? I know a 13-13.5 inch wheel should be good. thanks.