Radiator tranny lines snapped

Keith4452

New Member
Mar 6, 2006
14
0
0
I am about to throw a whole new tranny and motor into this newly bought car of mine if something doesn't go right. It's a 90 GT and when I was swaping out radiators I twisted and snapped the tranny lines going into the radiator. I thought I have just unscrewed the bolt when I was really just twisting the lines:bang: I am not a mechanic, but like to do things on my own to save money. I need new lines and proper installing procedure. Should I try it or have a mechanic come over because I've heard they are a pain in the a&$ to replace. Please help...I just want this car to be on the road for the summer:shrug:
 
Get some rubber hose and a flaring too (you can rent them at autozone) . cut the line where it snapped and flare the end of it and then splice it together with hose . just be sure it is not kinked and it will work fine .

At the bottom pf the pic you can see the hose spliced in:
Stangbronco085.jpg



Get some new NPT fittings from the Autopart store , like these to screw into the radiator and connect the hose to :

Stangbronco115.jpg



Good luck:nice:
 
That's some pretty good thinkin by Speedy. Make sure the rubber hose you get is for trannies/Power steering, or hydraulic fluids (for burst concerns). You might do something very similar if you installed an aux trans cooler anyhow.

Good luck.