Hey guys, like the title says.
1.) I'm having a hard time keeping the rubber part of the oil pan gasket in place while I put the cover back on. Any tips? it keeps either falling in or sticking out... isn't it supposed to be right on the outside egde, as opposed to inside the groove on the bottom of the cover?
2.) I can't seem to figure out which bolts go through the alignment dowel holes? What length should I be looking for?
3.) I think I might have to take the cover off and re-gasket tomorrow anyway, as when I stopped today (ran out of sunlight), I still couldn't get the cork corner gasket hiles to line up to put the bolts back in, as they kept sliding too.
Again, any tips? I used Motorcraft silicone (grey).
For those of youwho are aware of my broken bolt situation, I'll post about it later (long story)
Right now, I gotta go to bed
1.) I'm having a hard time keeping the rubber part of the oil pan gasket in place while I put the cover back on. Any tips? it keeps either falling in or sticking out... isn't it supposed to be right on the outside egde, as opposed to inside the groove on the bottom of the cover?
2.) I can't seem to figure out which bolts go through the alignment dowel holes? What length should I be looking for?
3.) I think I might have to take the cover off and re-gasket tomorrow anyway, as when I stopped today (ran out of sunlight), I still couldn't get the cork corner gasket hiles to line up to put the bolts back in, as they kept sliding too.
Again, any tips? I used Motorcraft silicone (grey).
For those of youwho are aware of my broken bolt situation, I'll post about it later (long story)
Right now, I gotta go to bed