rear end swap brake proportion valve

90topdown said:

Depends on how you did the swap. Did you swap in the whole rear assembly in one peice from the 95? Or did you try and put the 95 axles in to the 92 rear?

If you went the whole axle route, it should be fine except that the tires will stick out aout 3/4" on each side. The 95 rear is wider. Depending on what size tires yu are runinng you may have a clearance problem.

If you are putting the 95 axles into the 92 rear then you will need diffrent rear caliper brackets to compensate for the wider rear axles.

There is a ton of info here-- www.sn95brakes.com

In any case you wil have to gut the stock porprtioning valve and add an adjustable one with the rear discs.

Good luck

Click to expand...