release bearing Q

1967coupe

New Member

Feb 25, 2004

109

0

0

Wausau, WI

Aug 2, 2005

#1

• Aug 2, 2005

• #1

I'm putting a cable clutch setup w/T5 in my '67 and thought you guys could help. When installing the release bearing into the fork does it go all the way into the clips or is it supposed to pivot on the hump? I put it in all the way and can't get the tranny in because it doesn't line up. The bearing is a self adjusting type and the fork is a Jegs heavy duty. Any pics would be great. Thanks.

 

J

JB66

New Member

Aug 21, 2004

565

1

0

New York

Aug 2, 2005

#2

• Aug 2, 2005

• #2

Did you get the kit to reverse the direction?

 

1967coupe

New Member

Feb 25, 2004

109

0

0

Wausau, WI

Aug 2, 2005

#3

• Aug 2, 2005

• #3

Not too sure what you mean by that. I'm using the T5 bell, stock replacement fork/bearing/cable and a diaphram clutch. It should be no different then your rides. I've just been reading posts here that say you need to take note of how it's positioned when it's replaced so you can install it the same way. I just don't have anything to reference to.

 

Euphoric306

New Member

Apr 5, 2004

905

0

0

Aug 2, 2005

#4

• Aug 2, 2005

• #4

ummm, you did use a clutch alignment tool didnt you?

and i checked out the self-aligning bearing when i replaced my TOB, it didnt look like it would work with my stock fork... maybe you should try the non-sef-aligning and see if that makes a difference,

to answer your question though.. the TOB should go all the way into the fork clips

 

J

JB66

New Member

Aug 21, 2004

565

1

0

New York

Aug 2, 2005

#5

• Aug 2, 2005

• #5

Sorry, I may be confused here. Doesn't the stock T5 bell have the fork pivot on the pass. side of the housing?

 

Euphoric306

New Member

Apr 5, 2004

905

0

0

Aug 2, 2005

#6

• Aug 2, 2005

• #6

yup yup.. wuts the confusion?

 

1967coupe

New Member

Feb 25, 2004

109

0

0

Wausau, WI

Aug 2, 2005

#7

• Aug 2, 2005

• #7

thanks for the reply. The clutch has been in the car approx. 500 mi. I'm just switching over to a cable clutch setup because the old linkage started to go to crap on me with the better clutch. Plus it'll look alot cleaner under the hood.

 

J

JB66

New Member

Aug 21, 2004

565

1

0

New York

Aug 2, 2005

#8

• Aug 2, 2005

• #8

Sorry, my confusion! I went by his signature, thinking he had a 67. On the 67, the linkage pushes the fork which is pivoted on the driver side of the bell. The T5 is set up for a pull linkage since it pivots on the pass side.