Now about 2 weeks and 600 miles ago I had 3:73 gears installed in place of my 2:73 factory gears. And at 110 mph indicated (about 82-83 mph) I now have a vibration (sound not feel). I think it is two fold. Some of it is from the engine (Push in the clutch and most goes away) but some is also the driveline.
Talking to a guy here who put 4:10's in his '02 and he asked if I removed the dogbone (isolator) from the rear end. He said that when he researched his gear swap (he did a LOT of research and did the gears himself) he read that mustnags like the dogbone removed with the lower gears (higher numerically).
Anyone else hear this or do it?
My car is parked until I can get my suspension installed but that should be in less than 2 weeks assuming I have a LOT of problems doing it alone (with the newborn I can't work too much during the week and even weekends are for the family).
Thanks,
Chris
Talking to a guy here who put 4:10's in his '02 and he asked if I removed the dogbone (isolator) from the rear end. He said that when he researched his gear swap (he did a LOT of research and did the gears himself) he read that mustnags like the dogbone removed with the lower gears (higher numerically).
Anyone else hear this or do it?
My car is parked until I can get my suspension installed but that should be in less than 2 weeks assuming I have a LOT of problems doing it alone (with the newborn I can't work too much during the week and even weekends are for the family).
Thanks,
Chris