i want to replace the brake lines that are in the engine bay
master cyl to combination vlave and comb valve to brakes
im going to replace all lines except what runs to the back(already done)
i want to clean up the engine bay a little
do i have to keep all the bends the same or can i just route the lines wherever i want, however i want (theyll go the same place just in a different way)
master cyl to combination vlave and comb valve to brakes
im going to replace all lines except what runs to the back(already done)
i want to clean up the engine bay a little
do i have to keep all the bends the same or can i just route the lines wherever i want, however i want (theyll go the same place just in a different way)